| Topology | Full-Bridge Converter symmetrical isolated |
| IC revision | 1.0 |
The device is a full bridge motor driver intended for a wide range of automotive applications. The device incorporates a dual monolithic high-side driver and two low-side switches. All switches are designed using STMicroelectronics® well known and proven proprietary VIPower® M0 technology that allows to efficiently integrate on the same die a true Power MOSFET with an intelligent signal/protection circuitry. The three dice are assembled in a PowerSSO-36 package equipped with three exposed islands for optimized dissipation performances. This package is specifically designed for the harsh automotive environment and offers improved thermal performance thanks to exposed die pads. A Multisense_EN pin is available to enable the MultiSense diagnostic. The input signals INA and INB can directly interface the microcontroller to select the motor direction and the brake condition. Two selection pins (SEL0 and SEL1) are available to address to the microcontroller the information available on the Multisense. The Multisense pin allows to monitor the motor current by delivering a current proportional to the motor current value and provides also the diagnostic feedback according to the implemeted truth table. When MultiSense_EN pin is driven low, MultiSense pin is in high impedance condition. The PWM, up to 20 KHz, allows to control the speed of the motor in all possible conditions. In all cases, a low level state on the PWM pin turns off both the LSA and LSB switches.
Order Code | Datasheet | Simulation | Downloads | Status | Product series | Pins | PCB/Cable/Panel | Modularity | Type | λDom typ.(nm) | Emitting Color | λPeak typ.(nm) | λPeak V typ.(nm) | λPeak Y typ.(nm) | λDom V typ.(nm) | λDom Y typ.(nm) | IV typ.(mcd) | IV V typ.(mcd) | IV Y typ.(mcd) | VF typ.(V) | VF V typ.(V) | VF Y typ.(V) | Chip Technology | 2θ50% typ.(°) | C | Tol. C | VR(V (DC)) | Size | Operating Temperature | DF(%) | RISO | Ceramic Type | L(mm) | W(mm) | H(mm) | Fl(mm) | Packaging | L(µH) | IR(A) | ISAT(A) | RDC max.(mΩ) | fres(MHz) | Mount | Endurance(h) | IRIPPLE(mA) | Z(mΩ) | ILeak(µA) | Ø D(mm) | Version | Polarity | Samples | |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
![]() | WE-PDF SMT Power Inductor, 2, – | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWE-PDF SMT Power Inductor | Pins2 | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | Size1064 | Operating Temperature -40 °C up to +150 °C | – | – | – | Length10.2 mm | Width10.2 mm | Height6.1 mm | – | – | Inductance18 µH | Rated Current5 A | Saturation Current3.8 A | DC Resistance34.4 mΩ | Self Resonant Frequency18 MHz | MountSMT | – | – | – | – | – | VersionSMT | – | ||||
![]() | WR-TBL Series 322 - 3.81 mm Horizontal PCB Header, 2, PCB Header | Simulation– | Downloads6 files | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWR-TBL Series 322 - 3.81 mm Horizontal PCB Header | Pins2 | PCB/Cable/PanelCable | ModularityNo | TypePCB Header | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | Operating Temperature -40 °C up to +105 °C | – | – | – | Length8.81 mm | – | – | – | PackagingBox | – | Rated Current10.5 A | – | – | – | MountTHT | – | – | – | – | – | – | Polarity02 | ||
![]() | WR-WTB 2.54 mm Male Header, 4, – | Simulation– | Downloads7 files | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWR-WTB 2.54 mm Male Header | Pins4 | PCB/Cable/PanelPCB | – | TypeVertical | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | Operating Temperature -40 °C up to +105 °C | – | Insulation Resistance1000 MΩ | – | Length10.16 mm | – | – | – | PackagingBag | – | Rated Current3 A | – | – | – | MountTHT | – | – | – | – | – | – | – | ||
![]() | WR-BHD 2.54 mm Male, 16, – | Simulation– | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWR-BHD 2.54 mm Male | Pins16 | PCB/Cable/PanelPCB | – | TypeStraight | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | Operating Temperature -40 °C up to +105 °C | – | Insulation Resistance1000 MΩ | – | Length27.98 mm | – | – | – | PackagingTray | – | Rated Current3 A | – | – | – | MountTHT | – | – | – | – | – | VersionLow Profile | – | |||
![]() | WL-SMCW SMT Mono-color Chip LED Waterclear, –, – | Downloads27 files RAY files
| Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWL-SMCW SMT Mono-color Chip LED Waterclear | – | – | – | – | Dominant Wavelength [typ.]630 nm | Emitting ColorSuper Red | Peak Wavelength [typ.]645 nm | – | – | – | – | Luminous Intensity [typ.]60 mcd | – | – | Forward Voltage [typ.]1.9 V | – | – | Chip TechnologyAlInGaP | Viewing Angle Phi 0° [typ.]140 ° | – | – | – | Size0603 | Operating Temperature -40 °C up to +85 °C | – | – | – | Length1.6 mm | Width0.8 mm | Height0.7 mm | – | PackagingTape and Reel | – | – | – | – | – | MountSMT | – | – | – | – | – | Version | – | |||
![]() | WCAP-ASLI Aluminum Electrolytic Capacitors, –, – | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWCAP-ASLI Aluminum Electrolytic Capacitors | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | Capacitance220 µF | Capacitance±20% | Rated Voltage50 V (DC) | Size10.0 x 10.5 | Operating Temperature -55 °C up to +105 °C | Dissipation Factor12 % | Insulation Resistance0.454545 MΩ | – | Length10.5 mm | Width10.3 mm | – | – | Packaging15" Tape & Reel | – | – | – | – | – | MountV-Chip SMT | Endurance 2000 | Ripple Current650 mA | Impedance230 mΩ | Leakage Current110 µA | Diameter10 mm | VersionSMT | – | ||||
![]() | WCAP-ASLL Aluminum Electrolytic Capacitors, –, – | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWCAP-ASLL Aluminum Electrolytic Capacitors | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | Capacitance47 µF | Capacitance±20% | Rated Voltage25 V (DC) | Size6.3 x 5.5 | Operating Temperature -55 °C up to +105 °C | Dissipation Factor14 % | Insulation Resistance2.12766 MΩ | – | Length5.5 mm | Width6.6 mm | – | – | Packaging15" Tape & Reel | – | – | – | – | – | MountV-Chip SMT | Endurance 2000 | Ripple Current230 mA | Impedance440 mΩ | Leakage Current11.8 µA | Diameter6.3 mm | VersionSMT | – | ||||
| WCAP-CSGP MLCCs 50 V(DC), –, – | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWCAP-CSGP MLCCs 50 V(DC) | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | Capacitance100 pF | Capacitance±10% | Rated Voltage50 V (DC) | Size0805 | Operating Temperature -55 °C up to +125 °C | Dissipation Factor2.5 % | Insulation Resistance10 GΩ | Ceramic TypeX7R Class II | Length2 mm | Width1.25 mm | Height0.8 mm | Pad Dimension0.5 mm | Packaging7" Tape & Reel | – | – | – | – | – | – | – | – | – | – | – | – | – | |||||
| WCAP-CSGP MLCCs 50 V(DC), –, – | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWCAP-CSGP MLCCs 50 V(DC) | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | Capacitance33 nF | Capacitance±10% | Rated Voltage50 V (DC) | Size0805 | Operating Temperature -55 °C up to +125 °C | Dissipation Factor2.5 % | Insulation Resistance10 GΩ | Ceramic TypeX7R Class II | Length2 mm | Width1.25 mm | Height0.8 mm | Pad Dimension0.5 mm | Packaging7" Tape & Reel | – | – | – | – | – | – | – | – | – | – | – | – | – | |||||
| WCAP-CSGP MLCCs 50 V(DC), –, – | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWCAP-CSGP MLCCs 50 V(DC) | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | Capacitance100 nF | Capacitance±10% | Rated Voltage50 V (DC) | Size0805 | Operating Temperature -55 °C up to +125 °C | Dissipation Factor2.5 % | Insulation Resistance5 GΩ | Ceramic TypeX7R Class II | Length2 mm | Width1.25 mm | Height0.8 mm | Pad Dimension0.5 mm | Packaging7" Tape & Reel | – | – | – | – | – | – | – | – | – | – | – | – | – | |||||
| WCAP-CSGP MLCCs 50 V(DC), –, – | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWCAP-CSGP MLCCs 50 V(DC) | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | Capacitance4.7 µF | Capacitance±10% | Rated Voltage50 V (DC) | Size1210 | Operating Temperature -55 °C up to +125 °C | Dissipation Factor5 % | Insulation Resistance0.02 GΩ | Ceramic TypeX7R Class II | Length3.2 mm | Width2.5 mm | Height2.5 mm | Pad Dimension0.6 mm | Packaging7" Tape & Reel | – | – | – | – | – | – | – | – | – | – | – | – | – | |||||
![]() | WL-SBCD SMT Bi-color Chip LED Diffused, –, – | Simulation– | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWL-SBCD SMT Bi-color Chip LED Diffused | – | – | – | – | – | Emitting ColorYellow & Bright Green | – | Peak Wavelength (Bright Green) [typ.]575 nm | Peak Wavelength (Yellow) [typ.]591 nm | Dominant Wavelength (Bright Green) [typ.]573 nm | Dominant Wavelength (Yellow) [typ.]589 nm | – | Luminous Intensity (Bright Green) [typ.]60 mcd | Luminous Intensity (Yellow) [typ.]130 mcd | – | Forward Voltage (Bright Green) [typ.]2 V | Forward Voltage (Yellow) [typ.]2 V | Chip TechnologyAlInGaP | Viewing Angle Phi 0° [typ.]130 ° | – | – | – | Size0606 | Operating Temperature -40 °C up to +85 °C | – | – | – | Length1.6 mm | Width1.5 mm | Height0.55 mm | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – |