| Topology | Buck Converter |
| Switching frequency | 2000 kHz |
| IC revision | Rev 1 |
The C510 Power Component is a customizable PWM Multiphase Synchronous Buck, Current Mode Switching Regulator. Combine the C510 component with other Power Components to create a custom-defined, AnDAPT AmP on-demand power management device. The integrated, low-resistance switching Scalable Integrated MOSFETs (SIMs) provide up to 6A output current. The maximum current for the C510 Power Component is defined by the number of phases (2, 3, or 4) and the maximum current of the selected AmP device. Output voltage feedback is compared against an internal reference using a high-performance, voltage-error amplifier that provides tight voltage regulation accuracy under transient conditions. Pulse-width modulated (PWM), current-mode regulation is implemented with PID and slope compensation. The switching frequency is either generated internally via an oscillator with selectable frequencies or provided via an external pin. The C510 component has a customizable current switchover point between pulse-width modulation (PWM) for higher-current loads and pulse-skipping modulation (PSM) for low-current loads. The customizable output voltage is specified by the power engineer during customization using AnDAPT’s cloudbased WebAmp development software. The C510 component has customizable control and status pins including an optional enable input, an optional power-good output, and optional output flags to signal when the system triggers an overvoltage (OVP), overcurrent (OCP), or undervoltage lockout (UVLO) condition. The threshold values are specified by the power engineer using the WebAmp tool. The customizable soft-start and soft-stop slew rates plus ramp timing are also specified by the power engineer using the WebAmp tool.
Order Code | Datasheet | Simulation | Downloads | Status | Product series | λDom typ.(nm) | Emitting Color | λPeak typ.(nm) | IV typ.(mcd) | VF typ.(V) | Chip Technology | 2θ50% typ.(°) | W(mm) | H(mm) | IR(A) | To | Tl(mm) | Pins | L(nH) | LR(nH) | IR(A) | ISAT,10%(A) | ISAT,30%(A) | RDC(mΩ) | fres(MHz) | Material | IRP,40K(A) | RDC typ.(mΩ) | RDC max.(mΩ) | Mount | C | VR(V (DC)) | Endurance(h) | IRIPPLE(mA) | Z(mΩ) | ILeak(µA) | DF(%) | Ø D(mm) | L(mm) | Packaging | Samples | |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
![]() | WL-SMCW SMT Mono-color Chip LED Waterclear, 525 nm, Green | Downloads26 files RAY files
| Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWL-SMCW SMT Mono-color Chip LED Waterclear | Dominant Wavelength [typ.]525 nm | Emitting ColorGreen | Peak Wavelength [typ.]515 nm | Luminous Intensity [typ.]430 mcd | Forward Voltage [typ.]3.2 V | Chip TechnologyInGaN | Viewing Angle Phi 0° [typ.]140 ° | Width0.8 mm | Height0.7 mm | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | MountSMT | – | – | – | – | – | – | – | – | Length1.6 mm | PackagingTape and Reel | |||
![]() | WL-SMCW SMT Mono-color Chip LED Waterclear, 625 nm, Red | Downloads26 files RAY files
| Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWL-SMCW SMT Mono-color Chip LED Waterclear | Dominant Wavelength [typ.]625 nm | Emitting ColorRed | Peak Wavelength [typ.]630 nm | Luminous Intensity [typ.]250 mcd | Forward Voltage [typ.]2 V | Chip TechnologyAlInGaP | Viewing Angle Phi 0° [typ.]140 ° | Width0.8 mm | Height0.7 mm | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | MountSMT | – | – | – | – | – | – | – | – | Length1.6 mm | PackagingTape and Reel | |||
![]() | WE-HCM SMT High Current Flat Wire Inductor, –, – | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWE-HCM SMT High Current Flat Wire Inductor | – | – | – | – | – | – | – | Width7 mm | Height6.8 mm | – | – | – | Pins2 | Inductance250 nH | Rated Inductance246 nH | Rated Current25 A | Saturation Current @ 10%41.6 A | Saturation Current @ 30%46.5 A | DC Resistance0.37 mΩ | Self Resonant Frequency40 MHz | MaterialMnZn | Performance Rated Current54.3 A | – | – | MountSMT | – | – | – | – | – | – | – | – | Length10.1 mm | – | ||||
![]() | WCAP-ASLL Aluminum Electrolytic Capacitors, –, – | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWCAP-ASLL Aluminum Electrolytic Capacitors | – | – | – | – | – | – | – | Width8.3 mm | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | – | MountV-Chip SMT | Capacitance100 µF | Rated Voltage35 V (DC) | Endurance 5000 | Ripple Current450 mA | Impedance170 mΩ | Leakage Current35 µA | Dissipation Factor14 % | Diameter8 mm | Length10.5 mm | Packaging15" Tape & Reel | ||||
![]() | WE-XHMI SMT Power Inductor, –, – | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWE-XHMI SMT Power Inductor | – | – | – | – | – | – | – | Width6.45 mm | Height3 mm | Rated Current12 A | – | – | Pins2 | Inductance1000 nH | – | Rated Current12 A | Saturation Current @ 10%11 A | Saturation Current @ 30%24.95 A | DC Resistance5.5 mΩ | Self Resonant Frequency59 MHz | – | Performance Rated Current15.75 A | DC Resistance5.5 mΩ | DC Resistance6.05 mΩ | MountSMT | – | – | – | – | – | – | – | – | Length6.65 mm | – | ||||
![]() | WP-THRSH REDCUBE THR with external thread, –, – | Simulation– | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWP-THRSH REDCUBE THR with external thread | – | – | – | – | – | – | – | Width10 mm | Height8.5 mm | – | Outer ThreadM4 | Thread Length5 mm | Pins9 | – | – | Rated Current85 A | – | – | – | – | MaterialBrass | – | – | – | MountTHR | – | – | – | – | – | – | – | – | – | PackagingTape and Reel |