IC-Hersteller Onsemi

IC-Hersteller (103)

Onsemi NCL30488 | Demoboard NCL30488 20 W SSR EVB AND90015

Secondary Side Regulated LED Driver with the NCL30488

Details

TopologieSperrwandler
Eingangsspannung85-277 V
Ausgang 140 V / 0.5 A
IC-RevisionP1

Beschreibung

The NCL30488 [1] is a power factor corrected controller with primary side constant voltage (CV) and constant current (CC) control suitable for flyback, buck−boost or SEPIC converters. The NCL30488 is housed in an SOIC 8 package and targets high−performance LED drivers. These controller integrate a proprietary circuit for power factor correction and constant current control allowing to achieve a power factor above 0.9 and total harmonic distortion below 10% for universal mains input. This controller is normally primary side regulated, but the version (TBD) is compatible with secondary side regulation. In this version, the COMP pin features a pullup resistor to the internal reference voltage rail and allows directly connecting an optocoupler collector to the pin. The current−mode, quasi−resonant architecture of this controller optimizes the efficiency by turning on the MOSFET when the drain−source voltage is minimal (valley). The valley lockout and frequency foldback circuitry maintain high−efficiency performance in in light load during constant−voltage regulation.

Eigenschaften

  • High Voltage Startup
  • Quasi−resonant Peak Current−mode Control Operation
  • Primary Side Feedback
  • CC / CV Accurate Control Vin up to 320 V rms
  • Tight LED Constant Current Regulation of ±2% Typical
  • Digital Power Factor Correction
  • Cycle by Cycle Peak Current Limit
  • Wide Operating VCC Range
  • −40 to + 125°C
  • Robust Protection Features
  • Brown−Out
  • OVP on VCC
  • Constant Voltage / LED Open Circuit Protection
  • Winding Short Circuit Protection
  • Secondary Diode Short Protection
  • Output Short Circuit Protection
  • Thermal Shutdown
  • Line over Voltage Protection
  • This is a Pb−Free Device

Typische Anwendungen

  • Integral LED Bulbs, LED Power Driver Supplies, LED Light Engines

Weiterführende Informationen

Artikeldaten

Artikel Nr.
Daten­blatt
Simu­lation
Downloads
Status
Produktserie
C
VR 2(V (DC))
dV/dt(V/µs)
DF @ 1 kHz(%)
RISO
Raster(mm)
Verpackung
L(mH)
IR(A)
ISAT,10%(A)
RDC max.(Ω)
fres(MHz)
Version
IR 1(A)
L1(mH)
RDC1 max.(Ω)
VR(V (DC))
VT(V (AC))
Material
L(mm)
B(mm)
H(mm)
Montageart
VRMS(V)
VDC(V)
VBR(V)
IPeak(A)
Wmax(J)
PDiss(W)
VDE-Zulassung
Muster
WCAP-FTBE Folienkondensatoren, 47 nF, 504 V (DC)
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Kapazität47 nF
Nennspannung 2504 V (DC)
Spannungsanstiegsgeschwindigkeit100 V/µs
Verlustfaktor1 %
Isolationswiderstand9 GΩ
Raster7.5 mm
VerpackungKarton 
VersionTHT 
Nennspannung630 V (DC)
Länge10.5 mm
Breite6 mm
Höhe12 mm
WE-LF Stromkompensierte Netzdrossel, –, –
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität2.2 mH
Nennstrom2 A
Gleichstromwiderstand0.1 Ω
VersionTHT 
Nennstrom [1]2 A
Induktivität [1]2.2 mH
Gleichstromwiderstand [1]0.1 Ω
Nennspannung250 V (DC)
Prüfspannung1500 V (AC)
MaterialMnZn 
Länge18 mm
Breite18 mm
Höhe13 mm
MontageartTHT 
VDE-Zulassung40042531 
WE-VD Disk Varistor, –, –
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
VersionTHT 
Länge9 mm
Breite5.1 mm
Höhe13 mm
MontageartTHT 
Wechselstrom Betriebsspannung420 V
DC Betriebsspannung560 V
(Rückwärts-) Durchbruchspannung680 V
(Reverse) Peak Pulse Current1750 A
Energieabsorption56 J
Verlustleistung0.25 W
VDE-ZulassungJa 
WE-TI Tonneninduktivität, –, –
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität0.01 mH
Nennstrom1.85 A
Sättigungsstrom 12.5 A
Gleichstromwiderstand0.05 Ω
Eigenresonanzfrequenz28 MHz
VersionGestanzt 
Länge6 mm
Breite6 mm
Höhe6.5 mm
MontageartTHT 
750370980
Offline Transformer, –, –
Simu­lation
Downloads
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Produktserie Offline Transformer