| Topology | Boost Converter |
| Input voltage | 5-20 V |
| Switching frequency | 300-2000 kHz |
| Output 1 | 24 V / 1.4 A |
| IC revision | 1 |
The LT8364 is a current mode DC/DC converter with a 60V, 4A switch operating from a 2.8V to 60V input. With a unique single feedback pin architecture it is capable of boost, SEPIC or inverting configurations. Burst Mode operation consumes as low as 9μA quiescent current tomaintain high efficiency at very low output currents, while keeping typical output ripple below 15mV. An external compensation pin allows optimization of loop bandwidth over a wide range of input and output voltages and programmable switching frequencies between 300kHz and 2MHz. A SYNC/MODE pin allows synchronization to an external clock. It can also be used to select between burst or pulse-skip modes of operation with or without Spread Spectrum Frequency Modulation for low EMI. For increased efficiency, a BIAS pin can accept a second input to supply the INTVCC regulator. Additional features include frequency foldback and programmable soft-start to control inductor current during startup.The LT8364 is available in a thermally enhanced 12-lead 4mm × 3mm DFN package or a thermally enhanced 16-lead MSOP package with four pins removed.
Order Code | Datasheet | Simulation | Downloads | Status | Product series | L(µH) | IR(A) | ISAT1(A) | ISAT2(A) | fres(MHz) | IRP,40K(A) | ISAT,10%(A) | ISAT,30%(A) | Mount | Z @ 100 MHz(Ω) | Zmax(Ω) | Test Condition Zmax | IR 2(mA) | RDC max.(mΩ) | Type | Samples | |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
![]() | WE-PMCI Power Molded Chip Inductor, 0.47 µH, 7.1 A | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWE-PMCI Power Molded Chip Inductor | Inductance0.47 µH | Rated Current7.1 A | Saturation Current 15.15 A | Saturation Current 29.95 A | Self Resonant Frequency90 MHz | Performance Rated Current7.1 A | Saturation Current @ 10%5.15 A | Saturation Current @ 30%9.95 A | MountSMT | – | – | – | Rated Current 23600 mA | DC Resistance22 mΩ | – | ||||
![]() | WE-LHMI SMT Power Inductor, 2.2 µH, – | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWE-LHMI SMT Power Inductor | Inductance2.2 µH | – | – | – | Self Resonant Frequency49 MHz | Performance Rated Current4.05 A | Saturation Current @ 10%4.45 A | Saturation Current @ 30%8.4 A | MountSMT | – | – | – | – | DC Resistance61 mΩ | – | ||||
![]() | WE-CBF SMT EMI Suppression Ferrite Bead, –, 1.5 A | Status Activei| Production is active. Expected lifetime: >10 years. | Product seriesWE-CBF SMT EMI Suppression Ferrite Bead | – | Rated Current1.5 A | – | – | – | – | – | – | MountSMT | Impedance @ 100 MHz600 Ω | Maximum Impedance700 Ω | Maximum Impedance150 MHz | Rated Current 22000 mA | DC Resistance150 mΩ | TypeHigh Current |