Xilinx XCZU7EV-2FFVC1156 | Demoboard ZCU106

Beschreibung

The ZCU106 is a general purpose evaluation board for rapid-prototyping based on the ZU7EV silicon part and package in the 16 nm FinFET Zynq® UltraScale+™ MPSoC. The ZU7EV device integrates a quad core Arm® Cortex™-A53 processing system (PS) and a dual core Arm Cortex-R5F real-time processor, which provides application developers an unprecedented level of heterogeneous multiprocessing. The ZCU106 evaluation board provides a flexible prototyping platform with high-speed DDR4 memory interfaces, FMC expansion ports, multi-gigabit per second serial transceivers, video codec unit (VCU), several peripheral interfaces, and FPGA fabric for customized designs.

Eigenschaften

• XCZU7EV-2, FFVC1156 package
  • PL VCCINT for range in data sheet
  • Form factor for PCIe® Gen[1-3]x4 endpoint (PL GTH transceiver), Micro-ATX chassisfootprint
  • Configuration from Quad SPI
  • Configuration from SD card
  • Configuration over JTAG with platform cable USB header
  • Configuration over JTAG with Arm 20-pin header
  • Configuration over USB-to-JTAG bridge
  • Clocks
  • USER_MGT_SI570
  • PL_74.25M, PL_125M, PL_300M
  • USER_SMA_MGT
  • GTR_DP, GTR_USB3, GTR_SATA
  • PS_REF_CLK
  • PS DDR4 64-bit SODIMM
  • PL DDR4 64-bit component (4x16-bit)
  • PS-GTR assignment
  • DisplayPort (two GTRs)
  • USB3 (one GTR)
  • SATA (one GTR)
  • PL GTH transceiver assignment (20 total)
  • High-definition multimedia interface (HDMI®) (three GTH transceivers)
  • FMC HPC1 DP (one GTH transceiver)
  • PCIe (four GTH transceivers)
  • SDI (one GTH transceiver)
  • SMA (one GTH transceiver)
  • SFP+ (two GTH transceivers)
  • FMC HPC0 DP (eight GTH transceivers)
  • PL FMC HPC0 connectivity - full LA bus
  • PL FMC HPC1 connectivity - partial LA bus
  • PS MIO: dual Quad SPI
  • PS MIO: two channels of quad-UART bridge
  • PS MIO: CAN
  • PS MIO: I2C shared across PS and PL
  • PS MIO: SD
  • PS MIO: DisplayPort
  • PS MIO: system controller I/F
  • PS MIO: Ethernet
  • PS MIO: USB3
  • PS-side user LED (one)
  • PS-side user pushbutton (one)
  • PL-side user LEDs (eight)
  • PL-side user DIP switch (8-position)
  • PL-side user pushbuttons (five)
  • PL-side CPU reset pushbutton
  • PL-side PMOD headers
  • PL-side bank 0 PROG_B pushbutton
  • Security - PSBATT button battery backup
  • SYSMON (previously XADC), prototype header
  • Operational switches (power on/off, PROG_B, boot mode DIP switch)
  • Operational status LEDs (power status, INIT, DONE, PG, JTAG status, DDR power good)
  • Power management

Weiterführende Informationen

• Datenblatt