| Topologie | Abwärtswandler |
| Eingangsspannung | 4.5-17 V |
| Schaltfrequenz | 200-1600 kHz |
| Ausgang 1 | 12 V / 10 A |
| IC-Revision | A |
The TPS54A24 is a full-featured 17-V, 10-A synchronous step-down DC/DC converter in a standard 4 mm × 4 mm WQFN package.The device is optimized for small solution size through high efficiency and integrating the high-side and low-side MOSFETs. Further space savings are achieved through peak-current-mode control, which reduces component count, and by selecting a high switching frequency, reducing the inductor footprint.The peak-current-mode control simplifies the loop compensation and provides fast transient response. Cycle-by-cycle peak current limiting on the high-side and low-side sourcing current limit protects the device in overload situations. Hiccup limits MOSFET power dissipation if a short circuit or over loading fault persists.A power-good supervisor circuit monitors the regulator output. The PGOOD pin is an open-drain output and goes high impedance when the output voltage is in regulation. An internal deglitch time prevents the PGOOD pin from pulling low unless a fault has occurred.A dedicated EN pin can be used to control the regulator on/off and adjust the input undervoltage lockout. The output voltage start-up ramp is controlled by the SS/TRK pin, which allows operation as either a standalone power supply or in tracking situations.
Artikel Nr. | Datenblatt | Simulation | Downloads | Status | Produktserie | L(nH) | LR(nH) | IR(A) | ISAT,10%(A) | ISAT,30%(A) | RDC(mΩ) | fres(MHz) | Material | IRP,40K(A) | RDC typ.(mΩ) | RDC max.(mΩ) | Montageart | Muster | |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
![]() | WE-HCM SMT-Hochstrominduktivität, 400 nH, 345 nH | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWE-HCM SMT-Hochstrominduktivität | Induktivität400 nH | Nenninduktivität345 nH | Nennstrom25 A | Sättigungsstrom 123.8 A | Sättigungsstrom @ 30%28.3 A | Gleichstromwiderstand0.37 mΩ | Eigenresonanzfrequenz25 MHz | MaterialMnZn | Performance Nennstrom54.3 A | – | – | MontageartSMT | ||||
![]() | WE-XHMI SMT Speicherdrossel, 1000 nH, – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWE-XHMI SMT Speicherdrossel | Induktivität1000 nH | – | Nennstrom17 A | Sättigungsstrom 118.15 A | Sättigungsstrom @ 30%38.15 A | Gleichstromwiderstand2.1 mΩ | Eigenresonanzfrequenz53 MHz | – | Performance Nennstrom30.25 A | Gleichstromwiderstand2.1 mΩ | Gleichstromwiderstand2.32 mΩ | MontageartSMT | ||||
![]() | WE-LHMI SMT Speicherdrossel, 1000 nH, – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWE-LHMI SMT Speicherdrossel | Induktivität1000 nH | – | – | Sättigungsstrom 120.6 A | Sättigungsstrom @ 30%43.1 A | – | Eigenresonanzfrequenz42 MHz | – | Performance Nennstrom18.6 A | Gleichstromwiderstand3.65 mΩ | Gleichstromwiderstand4.63 mΩ | MontageartSMT | ||||
![]() | WE-XHMI SMT Speicherdrossel, 2200 nH, – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWE-XHMI SMT Speicherdrossel | Induktivität2200 nH | – | Nennstrom13 A | Sättigungsstrom 112.55 A | Sättigungsstrom @ 30%26.45 A | Gleichstromwiderstand3.7 mΩ | Eigenresonanzfrequenz33 MHz | – | Performance Nennstrom21.85 A | Gleichstromwiderstand3.7 mΩ | Gleichstromwiderstand4.07 mΩ | MontageartSMT | ||||
![]() | WE-XHMI SMT Speicherdrossel, 4700 nH, – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWE-XHMI SMT Speicherdrossel | Induktivität4700 nH | – | Nennstrom9.5 A | Sättigungsstrom 17.5 A | Sättigungsstrom @ 30%16.65 A | Gleichstromwiderstand8.65 mΩ | Eigenresonanzfrequenz22 MHz | – | Performance Nennstrom13.35 A | Gleichstromwiderstand8.65 mΩ | Gleichstromwiderstand9.51 mΩ | MontageartSMT |