| Topologie | Motor Drive |
| IC-Revision | B |
DRV8873 is an integrated driver for industrial and automotive applications. With 10 A peak current capability and 4.5-38V voltage range, this device supports a wide range of applications. PH/EN or PWM interface allows simple interfacing to controller circuits while also allowing independent ½ bridge control to drive two solenoid loads.A current mirror approximates the current through the high-side FETs, and does not require a sense resistor.A low-power sleep mode is provided to achieve very low quiescent current draw by shutting down much of the internal circuitry.Internal protection functions are provided for undervoltage lockout, charge pump faults, overcurrent protection, short circuit protection, and overtemperature with fault conditions indicated on a nFAULT pin and through the SPI registers.
Integrated current sensingMulti-level current regulationOpen-load detection4.5V minimum operating supplyCharge pump architecture
Artikel Nr. | Datenblatt | Simulation | Downloads | Status | Produktserie | Pins | PCB/Kabel/Panel | Modularity | Typ | Wire Section | λDom typ.(nm) | Emittierte Farbe | λPeak typ.(nm) | IV typ.(mcd) | VF typ.(V) | Chiptechnologie | 2θ50% typ.(°) | C | Tol. C | VR(V (DC)) | Bauform | Betriebstemperatur | DF(%) | RISO | Keramiktyp | L(mm) | B(mm) | H(mm) | Fl(mm) | Verpackung | Muster | |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
![]() | WR-TBL Series 101 - 5.00 mm Horizontal Entry Modular, 2, Kabelschutzprinzip | Simulation– | Downloads6 Dateien | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | Pins2 | PCB/Kabel/PanelPCB | ModularityJa | TypHorizontal | Wire Section 26 to 14 (AWG) 0.5 to 2.5 (mm²) | – | – | – | – | – | – | – | – | – | – | – | Betriebstemperatur -40 °C up to +105 °C | – | – | – | Länge10 mm | – | Höhe12.6 mm | – | VerpackungKarton | |||
![]() | WL-SMCW SMT Mono-color Chip LED Waterclear, –, – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWL-SMCW SMT Mono-color Chip LED Waterclear | – | – | – | – | – | dominante Wellenlänge [typ.]630 nm | Emittierte FarbeSuperrot | Spitzen-Wellenlänge [typ.]645 nm | Lichtstärke [typ.]60 mcd | Durchlassspannung [typ.]1.9 V | ChiptechnologieAlInGaP | Abstrahlwinkel Phi 0° [typ.]140 ° | – | – | – | Bauform0805 | Betriebstemperatur -40 °C up to +85 °C | – | – | – | Länge2 mm | Breite1.25 mm | Höhe0.7 mm | – | VerpackungTape and Reel | ||||
![]() | WL-SMCW SMT Mono-color Chip LED Waterclear, –, – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWL-SMCW SMT Mono-color Chip LED Waterclear | – | – | – | – | – | dominante Wellenlänge [typ.]570 nm | Emittierte FarbeHellgrün | Spitzen-Wellenlänge [typ.]572 nm | Lichtstärke [typ.]40 mcd | Durchlassspannung [typ.]2 V | ChiptechnologieAlInGaP | Abstrahlwinkel Phi 0° [typ.]140 ° | – | – | – | Bauform0805 | Betriebstemperatur -40 °C up to +85 °C | – | – | – | Länge2 mm | Breite1.25 mm | Höhe0.7 mm | – | VerpackungTape and Reel | ||||
| WCAP-CSGP MLCCs 10 V(DC), –, – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWCAP-CSGP MLCCs 10 V(DC) | – | – | – | – | – | – | – | – | – | – | – | – | Kapazität100 nF | Kapazität±10% | Nennspannung10 V (DC) | Bauform0603 | Betriebstemperatur -55 °C up to +125 °C | Verlustfaktor5 % | Isolationswiderstand5 GΩ | KeramiktypX7R Klasse II | Länge1.6 mm | Breite0.8 mm | Höhe0.8 mm | Pad Dimension0.4 mm | Verpackung7" Tape & Reel | |||||
| WCAP-CSGP MLCCs 16 V(DC), –, – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWCAP-CSGP MLCCs 16 V(DC) | – | – | – | – | – | – | – | – | – | – | – | – | Kapazität1 nF | Kapazität±10% | Nennspannung16 V (DC) | Bauform0603 | Betriebstemperatur -55 °C up to +125 °C | Verlustfaktor3.5 % | Isolationswiderstand10 GΩ | KeramiktypX7R Klasse II | Länge1.6 mm | Breite0.8 mm | Höhe0.8 mm | Pad Dimension0.4 mm | Verpackung7" Tape & Reel |