IC-Hersteller STMicroelectronics

IC-Hersteller (96)

STMicroelectronics STSPIN32G4 | Demoboard EVSPIN32G4

STSPIN32G4 demonstration board for three-phase brushless motors

Details

TopologieMotor Drive
Eingangsspannung10-75 V
IC-Revision1

Beschreibung

The EVSPIN32G4 is a demonstration board based on the STSPIN32G4 system in package and STL110N10F7 power MOSFETs. The STSPIN32G4 integrates in a 9x9 mm VFQFPN package, a triple high-performance half-bridge gate driver with a rich set of programmable features and one mixed signal STM32G431 microcontroller. The integrated operational amplifiers for current sensing, the drain-source voltage sensing of each power MOSFET and comparators for overcurrent protection make it a fully integrated solution for motor control. Thanks to the integrated voltage regulators both the gate driver and control logic supplies can be generated starting from the motor supply without dedicated circuitry. The board ensures a full evaluation of the STSPIN32G4 and is designed for driving three-phase brushless DC motors and provides an easy-to-use solution for STSPIN32G4 evaluation in different applications such as power tools, e-Bikes, fans, and home appliances. The board can be configured in three-shunt or single-shunt supporting both sensor less and sensor-based control algorithms. The Arduino connector enables the EVSPIN32G4 to be interfaced with expansion boards, such as MEMS sensors or Bluetooth transceivers, while predisposition for CAN bus allows interconnection with master or slave modules to build complex motion control systems. The on-board ST-LINK/V2 programmer speeds up and simplifies the debugging of microcontroller firmware.

Eigenschaften

  • Input bus voltage from 10 V to 75 V with dedicated monitoring
  • Power stage based on the STL110N10F7 power MOSFETs with output current up to 20 Arms (with heatsink mounted) and protected to overcurrent conditions
  • STSPIN32G4, high performance three-phase motor controller with embedded
  • STM32G431 MCU:– 32-bit ARM® Cortex®-M4 MCU+FPU– Up to 170 MHz clock frequency– CORDIC mathematical hardware accelerator for trigonometric functions– 128 kB Flash memory with proprietary code readout protection (PCROP),securable memory area, 1 kB OTP– 32 kB SRAM memory with HW parity check– 2 x advanced timers for motor control, 16-bit with up to 6 x PWM channelseach– 8 x general purpose timers– 2 x ADCs 12-bit resolution (up to 19 channels) with 4 Msps conversion rate– 4 x 12-bit DAC channels– 4 x ultra-fast rail-to-rail comparators– 3 x rail-to-rail operational amplifiers usable also in PGA mode– Internal high precision voltage reference– Up to 40 GPIOs– Full set of interfaces: I2C, SPI, UART and CAN– VCC buck converter up to 200 mA, with programmable output andembedded MOSFET– 3.3 V LDO linear regulator up to 150 mA– Low quiescent linear regulator for MCU supply in standby mode– Regulators with full set of protection features; thermal shutdown, shortcircuit and overload protections– 75 V rated gate drivers with 1 A sink/source current and embeddedbootstrap diodes– Drain-source voltage sensing of each power MOSFET
  • Three-shunt or single-shunt configurable current sensing
  • Digital Hall sensor and quadrature encored input
  • ST-LINK/V2 programmer and debugger
  • Arduino UNO connector
  • Predisposition for CAN bus
  • NTC sensor for power stage temperature monitoring

Typische Anwendungen

  • Power and garden tools
  • Industrial and home automation, Home appliances such as vacuum cleaners,dryers and cleaning robots, Servo drives and e-bikes, Service and automation robots, Pumps and fans, Drones and aeromodelling

Weiterführende Informationen

Artikeldaten

Artikel Nr. Daten­blatt Simu­lation Downloads ProduktserieλDom typ.
(nm)
FarbeλPeak typ.
(nm)
IV typ.
(mcd)
VF typ.
(V)
Chiptechnologie50% typ.
(°)
CTol. CVR
(V (DC))
BauformBetriebstemperaturQ
(%)
DF
(%)
RISOKeramiktypL
(mm)
W
(mm)
Fl
(mm)
L
(µH)
ISAT
(A)
RDC max.
(Ω)
fres
(MHz)
AnwendungInterface typMontageartIR 1
(A)
Arbeitsspannung
(V (AC))
Endurance
(h)
BetriebstemperaturIRIPPLE
(mA)
ILeak
(µA)
Raster
(mm)
Ø D
(mm)
H
(mm)
Betätigungskraft (Value)
(g)
Elektrische Lebensdauer
(Cycles)
Actuator-FarbeDampfphasenprozessPinsReihenGenderTypIR
(A)
VerpackungFarbe Muster
150060YS75000SPEC
25 Dateien WL-SMCW SMT Mono-color Chip LED Waterclear 590 Gelb 595 120 2 AlInGaP 140 0603 -40 °C up to +85 °C 1.6 0.8 SMT -40 °C up to +85 °C 0.7 Tape and Reel
150080RS75000SPEC
7 Dateien WL-SMCW SMT Mono-color Chip LED Waterclear 625 Rot 630 150 2 AlInGaP 140 0805 -40 °C up to +85 °C 2 1.25 SMT 0.7 Tape and Reel
744045180SPEC
8 Dateien WE-LQ SMT-Induktivität 1812 -40 °C up to +125 °C 42 4.5 3.2 18 1.1 0.6 22 SMT -40 °C bis zu +125 °C 2.6 0.68
885012206076SPEC
8 Dateien WCAP-CSGP MLCCs 25 V(DC)1 µF ±10% 25 0603 -55 °C up to +125 °C 100.5 GΩ X7R Klasse II 1.6 0.8 0.4 0.8 7" Tape & Reel
885012207078SPEC
7 Dateien WCAP-CSGP MLCCs 25 V(DC)1 µF ±10% 25 0805 -55 °C up to +125 °C 50.5 GΩ X7R Klasse II 2 1.25 0.5 1.25 7" Tape & Reel
61300611821SPEC
6 Dateien WR-PHD 2.54 mm Socket Header -40 °C up to +105 °C1000 MΩ 15.74 THT 250 2.54 6 Single Socket Header Gerade 3 Tray
61301011821SPEC
6 Dateien WR-PHD 2.54 mm Socket Header -40 °C up to +105 °C1000 MΩ 25.9 THT 250 2.54 10 Single Socket Header Gerade 3 Tray
62201021121SPEC
6 Dateien WR-PHD 1.27 mm THT Dual Pin Header -40 °C up to +105 °C500 MΩ 6.35 THT 1 100 -40 °C bis zu +105 °C 1.27 10 Dual Pin Header Gerade 1 Karton
629105150521SPEC
6 Dateien WR-COM Micro USB 2.0 SMT Type B Horizontal 5 Contacts High Current -40 °C up to +85 °C1000 MΩ Micro USB 2.0 Type B SMT 3 30 -40 °C bis zu +85 °C 5 Receptacle Horizontal 3 Tape and Reel Schwarz
430483025816SPEC
6 Dateien WS-TASV J-Bend SMT Washable Tact Switch 6x6 mm 12 -40 °C up to +85 °C100 MΩ 2.5 160 1000000 Schwarz nicht spezifiziert 0.05 Tape and Reel
60900213421SPEC
3 Dateien WR-PHD 2.54 mm Multi-Jumper Jumper with Test Point -40 °C up to +125 °C1000 MΩ 2.44 250 2.54 1 Jumper 3 Beutel Schwarz
61300211121SPEC
6 Dateien WR-PHD 2.54 mm THT Pin Header -40 °C up to +105 °C1000 MΩ 5.08 THT 250 2.54 2 Single Pin Header Gerade 3 Beutel
61300311121SPEC
6 Dateien WR-PHD 2.54 mm THT Pin Header -40 °C up to +105 °C1000 MΩ 7.62 THT 250 2.54 3 Single Pin Header Gerade 3 Beutel
61300411121SPEC
6 Dateien WR-PHD 2.54 mm THT Pin Header -40 °C up to +105 °C1000 MΩ 10.16 THT 250 2.54 4 Single Pin Header Gerade 3 Beutel
61300511121SPEC
6 Dateien WR-PHD 2.54 mm THT Pin Header -40 °C up to +105 °C1000 MΩ 12.7 THT 250 2.54 5 Single Pin Header Gerade 3 Beutel
61300811821SPEC
6 Dateien WR-PHD 2.54 mm Socket Header -40 °C up to +105 °C1000 MΩ 20.82 THT 250 2.54 8 Single Socket Header Gerade 3 Tray
7447732115SPEC
8 Dateien WE-PD2 SMT-Speicherdrossel 3521 -40 °C up to +125 °C 3 3.5 15 1.01 0.43 36 SMT -40 °C bis zu +125 °C 2.1 0.64
860040878017SPEC
3 Dateien WCAP-ATUL Aluminium-Elektrolytkondensatoren220 µF ±20% 100 -40 °C up to +105 °C 8 25 Radial THT 10000 -40 °C bis zu +105 °C 2220 220 5 13 Ammopack
Muster
Artikel Nr. Daten­blatt Simu­lation Downloads ProduktserieλDom typ.
(nm)
FarbeλPeak typ.
(nm)
IV typ.
(mcd)
VF typ.
(V)
Chiptechnologie50% typ.
(°)
CTol. CVR
(V (DC))
BauformBetriebstemperaturQ
(%)
DF
(%)
RISOKeramiktypL
(mm)
W
(mm)
Fl
(mm)
L
(µH)
ISAT
(A)
RDC max.
(Ω)
fres
(MHz)
AnwendungInterface typMontageartIR 1
(A)
Arbeitsspannung
(V (AC))
Endurance
(h)
BetriebstemperaturIRIPPLE
(mA)
ILeak
(µA)
Raster
(mm)
Ø D
(mm)
H
(mm)
Betätigungskraft (Value)
(g)
Elektrische Lebensdauer
(Cycles)
Actuator-FarbeDampfphasenprozessPinsReihenGenderTypIR
(A)
VerpackungFarbe Muster