IC-Hersteller Onsemi

IC-Hersteller (103)

Onsemi FAN9611

FAN9611 Interleaved Dual BCM PFC Controller

Details

TopologieLeistungsfaktor-Korrektur
Eingangsspannung90-265 V
Schaltfrequenz16.5-525 kHz
Ausgang 1400 V / 1 A
IC-Revision1.1.7

Beschreibung

The FAN9611 interleaved dual Boundary-Conduction-Mode (BCM) Power-Factor-Correction (PFC) controller operates two parallel-connected boost power trains 180° out of phase. Interleaving extends the maximum practical power level of the control technique from about 300 W to greater than 800 W. Unlike the continuous conduction mode (CCM) technique often used at higher power levels, BCM offers inherent zero-current switching of the boost diodes, which permits the use of less expensive diodes without sacrificing efficiency. Furthermore, the input and output filters can be smaller due to ripple current cancellation and effective doubling of the switching frequency.

The converters operate with variable frequency, which is a function of the load and the instantaneous input / output voltages. The switching frequency is limited between 16.5 kHz and 525 kHz. The Pulse Width Modulators (PWM) implement voltage-mode control with input voltage feedforward. When configured for PFC applications, the slow voltage regulation loop results in constant on-time operation within a line cycle. This PWM method, combined with the BCM operation of the boost converters, provides automatic power factor correction.

The controller offer bias UVLO of 10 V / 7.5 V, input brownout, over-current, open-feedback, output over-voltage, and redundant latching over-voltage protections. Furthermore, the converters’ output power is limited independently of the input RMS voltage. Synchronization between the power stages is maintained under all operating conditions.

Eigenschaften

  • Sync-Lock™ Interleaving Technology for 180° Out-of-Phase Synchronization Under All Conditions
  • Automatic Phase Disable at Light Load
  • Dead-Phase Detect Protection2.0A Sink, 1.0A Source, High-Current Gate Drivers
  • High Power Factor, Low Total Harmonic Distortion
  • Voltage-Mode Control with (VIN)2 Feedforward
  • Closed-Loop Soft-Start with User-Programmable Soft-Start Time for Reduced Overshoot
  • Minimum Restart Frequency to Avoid Audible Noise
  • Maximum Switching Frequency Clamp
  • Brownout Protection with Soft Recovery
  • Non-Latching OVP on FB Pin and Latching Second-Level Protection on OVP Pin
  • Open-Feedback Protection
  • Power-Limit and Current
  • Protection for Each Phase
  • Low Startup Current of 80µA Typical
  • Works with DC and 50Hz to 400Hz AC Inputs

Remarks:L1,L2=280uH L3,L4=9mH UsedRefer page no.7

L1,L2=200uH And L3,L4 UsedRefer page no.7

Typische Anwendungen

  • Large Screen LCD-TV,PDP-TV,RP-TV Power
  • Networking and Televom Power Supplies
  • High-Effciency Desktop and Server Power Supplier
  • Solar Micro Inverters
  • 100-1000W AC-DC Power Supplies

Weiterführende Informationen

Artikeldaten

Artikel Nr.
Daten­blatt
Simu­lation
Downloads
Status
Produktserie
λDom typ.(nm)
Emittierte Farbe
λPeak typ.(nm)
IV typ.(mcd)
VF typ.(V)
Chiptechnologie
50% typ.(°)
Pins
Farbe
Gender
Verpackung
IR(A)
L(mH)
RDC max.(mΩ)
VR(V (AC))
VT(V (AC))
Material
L(mm)
B(mm)
H(mm)
Montageart
VRMS(V)
VDC(V)
VBR(V)
IPeak(A)
Wmax(J)
PDiss(mW)
VDE-Zulassung
Q(%)
IR 1(mA)
Muster
WL-TMRC THT Mono-color Round Color, 572 nm, Hellgrün
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
dominante Wellenlänge [typ.]572 nm
Emittierte FarbeHellgrün 
Spitzen-Wellenlänge [typ.]573 nm
Lichtstärke [typ.]140 mcd
Durchlassspannung [typ.]2.1 V
ChiptechnologieAlInGaP 
Abstrahlwinkel Phi 0° [typ.]40 °
VerpackungLose 
Länge5 mm
Breite5 mm
Höhe8.6 mm
MontageartTHT 
Verlustleistung75 mW
WE-CMB Stromkompensierte Netzdrossel, –, –
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Pins
Nennstrom20 A
Induktivität1.3 mH
Gleichstromwiderstand6.2 mΩ
Nennspannung250 V (AC)
Prüfspannung1500 V (AC)
MaterialMnZn 
Länge43.5 mm
Breite23.5 mm
Höhe43 mm
MontageartTHT 
VDE-Zulassung40042670 
WE-VD Disk Varistor, –, –
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Länge23 mm
Breite5.3 mm
Höhe27 mm
MontageartTHT 
Wechselstrom Betriebsspannung320 V
DC Betriebsspannung418 V
(Rückwärts-) Durchbruchspannung510 V
(Reverse) Peak Pulse Current10000 A
Energieabsorption382 J
Verlustleistung1000 mW
VDE-ZulassungJa 
WE-MI SMT-Multilayer-Induktivitäten, –, –
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Nennstrom0.05 A
Induktivität0.001 mH
Gleichstromwiderstand400 mΩ
Länge2 mm
Breite1.2 mm
Höhe0.9 mm
MontageartSMT 
Güte45 %
Nennstrom 150 mA
750311795
Common Mode Choke, –, –
Simu­lation
Downloads
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Produktserie Common Mode Choke
750341924
Power Transformer, –, –
Simu­lation
Downloads
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Produktserie Power Transformer
750341925
Power Transforme, –, –
Simu­lation
Downloads
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Produktserie Power Transforme
750341926
Power Inductor, –, –
Simu­lation
Downloads
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Produktserie Power Inductor
750341927
Power Transformer, –, –
Simu­lation
Downloads
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Produktserie Power Transformer
WR-PHD Kurzschlussbrücken, –, –
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Pins
FarbeSchwarz 
GenderJumper 
VerpackungBeutel 
Nennstrom3 A
Länge2.44 mm