IC-Hersteller ISSI

IC-Hersteller (103)

ISSI IS32LT3952-GRLA3-EB | Demoboard IS31LT3952_IS32LT3952 DEMO BOARD

CONSTANT-CURRENT 1.5-AMPERE PWM DIMMABLE BUCK REGULATOR LED DRIVER WITH FAULT PROTECTION

Details

TopologieAbwärtswandler
Eingangsspannung4.5-38 V
Schaltfrequenz1-2000 kHz
Ausgang 11.5 A
IC-RevisionA

Beschreibung

The IS31LT3952_IS32LT3952 is a DC-to-DC switchingconverter, which integrate an N-channel MOSFET tooperate in a buck configuration. The device supply awide input voltage between 4.5V and 38V andprovides a constant current of up to 1.5A for driving asingle LED or multiple series connected LEDs.The external resistor, RSET, is used to adjust LEDoutput current, which allowing the output voltage to beautomatically adjusted for a variety of LEDconfigurations.The IS31LT3952_IS32LT3952 operates in a fixedfrequency mode during switching. There is an externalresistor connected between the VCC and TON pinsused to configure the on-time (switching frequency).The switching frequency is dithered for spreadspectrum feature to spread the electromagneticemitting energy into a wider frequency band. It ishelpful to optimize the EMI performance.A logic input PWM signal to the enable (EN) pin isapplied to adjust the LED current. The brightness ofLED is proportional to the duty cycle of the PWMsignal.True average output current operation is achieved withfast transient response by using cycle-by-cycle,controlled on-time method.IS31LT3952_IS32LT3952 is available in an SOP-8-EPpackage with an exposed pad for enhanced thermaldissipation. It operates from 4.5V to 38V over thetemperature range of -40°C to +125°C.

Eigenschaften

  • Wide input voltage supply from 4.5V to 38V
    • Withstand 40V load dump
  • ±5% true average output current control
  • 1.5A maximum output over operating temperature range
  • Cycle-by-cycle current limit
  • Integrated high-side MOSFET switch
  • Dimming via direct logic input or power supply voltage
  • Internal control loop compensation
  • Under-voltage lockout (UVLO) and thermal shutdown protection
  • 2μA low power shutdown
  • Spread spectrum to optimize EMI
  • Robust fault protection:
  • Pin-to-GND short
  • Component open/short faults
  • Adjacent pin-to-pin short
  • LED open/short
  • AEC-Q100 qualification IS32LT3952 only

Typische Anwendungen

  • Automotive and avionic lighting / Daytime running lights / Turn/stop lights / Front and rear fog lights / Map light
  • Dimmable interior lights

Weiterführende Informationen

Artikeldaten

Artikel Nr.
Daten­blatt
Simu­lation
Downloads
Status
Produktserie
L(µH)
IRP,40K(A)
ISAT(A)
RDC max.(mΩ)
fres(MHz)
Bauform
Version
ISAT,10%(A)
ISAT,30%(A)
IR,40K(A)
Muster
WE-PD SMT-Speicherdrossel, 10 µH, 7.7 A
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität10 µH
Performance Nennstrom7.7 A
Sättigungsstrom5.5 A
Gleichstromwiderstand24 mΩ
Eigenresonanzfrequenz21.5 MHz
Bauform1260 
VersionGestanzt 
Sättigungsstrom 15.5 A
Sättigungsstrom @ 30%7.2 A
Nennstrom5 A
WE-PD Speicherdrossel, 10 µH, 9.5 A
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität10 µH
Performance Nennstrom9.5 A
Gleichstromwiderstand21 mΩ
Eigenresonanzfrequenz21 MHz
Bauform1210 
VersionGestanzt 
Sättigungsstrom 110.5 A
Sättigungsstrom @ 30%13 A
Nennstrom7.1 A
WE-PD SMT-Speicherdrossel, 15 µH, 7 A
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität15 µH
Performance Nennstrom7 A
Sättigungsstrom4.5 A
Gleichstromwiderstand28 mΩ
Eigenresonanzfrequenz16.6 MHz
Bauform1260 
VersionGestanzt 
Sättigungsstrom 14.5 A
Sättigungsstrom @ 30%5.8 A
Nennstrom4.2 A
WE-PD Speicherdrossel, 15 µH, 7.4 A
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität15 µH
Performance Nennstrom7.4 A
Gleichstromwiderstand26 mΩ
Eigenresonanzfrequenz17 MHz
Bauform1210 
VersionGestanzt 
Sättigungsstrom 18 A
Sättigungsstrom @ 30%9.8 A
Nennstrom6.5 A
WE-PD SMT-Speicherdrossel, 22 µH, 6 A
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität22 µH
Performance Nennstrom6 A
Sättigungsstrom3.7 A
Gleichstromwiderstand36 mΩ
Eigenresonanzfrequenz13.5 MHz
Bauform1260 
VersionGestanzt 
Sättigungsstrom 13.7 A
Sättigungsstrom @ 30%4.8 A
Nennstrom3.5 A
WE-PD Speicherdrossel, 22 µH, 7 A
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität22 µH
Performance Nennstrom7 A
Gleichstromwiderstand28 mΩ
Eigenresonanzfrequenz10 MHz
Bauform1210 
VersionGestanzt 
Sättigungsstrom 16.5 A
Sättigungsstrom @ 30%8 A
Nennstrom5.3 A
WE-PD SMT-Speicherdrossel, 33 µH, 4.6 A
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität33 µH
Performance Nennstrom4.6 A
Sättigungsstrom3 A
Gleichstromwiderstand57 mΩ
Eigenresonanzfrequenz11 MHz
Bauform1260 
VersionGestanzt 
Sättigungsstrom 13 A
Sättigungsstrom @ 30%3.9 A
Nennstrom2.8 A
WE-PD SMT-Speicherdrossel, 33 µH, 5.5 A
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität33 µH
Performance Nennstrom5.5 A
Gleichstromwiderstand45 mΩ
Eigenresonanzfrequenz8.5 MHz
Bauform1210 
VersionGestanzt 
Sättigungsstrom 15.5 A
Sättigungsstrom @ 30%6.8 A
Nennstrom4.2 A
WE-PD Speicherdrossel, 47 µH, 4.9 A
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität47 µH
Performance Nennstrom4.9 A
Gleichstromwiderstand60 mΩ
Eigenresonanzfrequenz6.5 MHz
Bauform1210 
VersionGestanzt 
Sättigungsstrom 14.5 A
Sättigungsstrom @ 30%5.5 A
Nennstrom3.8 A
WE-PD SMT-Speicherdrossel, 47 µH, 4.1 A
Simu­lation
Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre.
Induktivität47 µH
Performance Nennstrom4.1 A
Sättigungsstrom2.6 A
Gleichstromwiderstand77 mΩ
Eigenresonanzfrequenz9.2 MHz
Bauform1260 
VersionGestanzt 
Sättigungsstrom 12.6 A
Sättigungsstrom @ 30%3.4 A
Nennstrom2.4 A