STMicroelectronics STLUX385A

Beschreibung

The STLUX385A device is part of the STLUX™ family of STMicroelectronics® digital devices tailored for lighting and power conversion applications. The STLUX385A has been successfully integrated in a wide range of architectures and applications, starting from simple buck converters for driving multiple LED strings, boost for power factor corrections, half-bridge resonant converters for high power dimmable LED strings and up to full bridgecontrollers for HID lamp ballasts.

Eigenschaften

• 6 programmable PWM generators (SMEDs)
• (state machine event driven)
• 10 ns event detection and reaction
• Max.1.3 ns PWM resolution
• Single, coupled and two coupled
• operational modes
• Up to 3 internal/external events per SMED
• DALI (digital addressable lighting interface)
• Interrupt driven hardware encoder
• Bus frequency: 1.2, 2.4 or 4.8 kHz
• IEC 60929 and IEC 62386 compliant plus
• 24-bit frame extension
• Configurable noise rejection filter
• Reverse polarity on Tx/Rx lines
• 4 analog comparators
• 4 internal 4-bit references
• 1 external reference
• Less than 50 ns propagation time
• Continuous comparison cycle
• 8 analog-to-digital converters (ADCs)
• 10-bit precision, with operational amplifier to extend resolution to 12-bit equivalent
• Sequencer functionality
• Input impedance: 1 M
• Configurable gain value: x 1 or x 4
• Integrated microcontroller
• Advanced STM8® core with Harvard
• architecture and 3-stage pipeline
• Max. fCPU: 16 MHz Memories
• Flash and E2PROM with read while write
• (RWW) and error correction code (ECC)
• Program memory: 32 Kbytes Flash; data
• retention 15 years at 85 °C after 10 kcycles at 25 °C
• Data memory: 1 Kbyte true data E2PROM;
• data retention:15 years at 85 °C after 100
• kcycles at 85 °C
• RAM: 2 Kbytes
• ROM: 2 Kbytes
• Clock management
• Internal 96 MHz PLL
• Low-power oscillator circuit for external
• crystal resonator or direct clock input
• Internal, user-trimmable 16 MHz RC and low-power 153.6 kHz RC oscillators
• Clock security system with clock monitor
• Basic peripherals
• System and auxiliary timers
• IWDG/WWDG watchdog, AWU, ITC
• Reset and supply management
• Multiple low-power modes (wait, slow, autowakeup,
• Halt) with user definable clock
• gating
• Low consumption power-on and powerdown
• reset
• I/O
• 12 multifunction bidirectional GPIO with
• highly robust design, immune against
• current injection
• 6 fast digital input DIGIN, with configurable pull-up
• Communication interfaces
• UART asynchronous with SW flow control
• I2C master/slave fast-slow speed rate
• Operating temperature
• –40 °C up to 105 °C.

Weiterführende Informationen

• Datenblatt
• Produktseite des IC-Herstellers