Microchip MCP8025 | Demoboard ADM00600

Beschreibung

The MCP8025 TQFP BLDC Motor Driver Evaluation Board demonstrates Microchip’s 3-Phase Brushless DC (BLDC) Motor Gate Driver with Power Module, MCP8025, used in a BLDC motor drive application. When used in conjunction with a microcontroller, the MCP8025 will provide the necessary drive signals to drive for a 3-Phase BLDC motor. The MCP8025 contains the high-side and low-side drivers for external N-channel MOSFETs. A dsPIC33EP256MC504 processor is used to supply the PWM inputs to the MCP8025 as well as handle the high-speed Analog-To-Digital Conversion (ADC) required for 50 kHz PWM operation. The MCP8025 UART interface is used to configure the MCP8025 device and to send fault information to the dsPIC ® DSC controller. The evaluation board firmware uses a 6-step trapezoidal drive control algorithm to demonstrate the MCP8025 capabilities.

Eigenschaften

• Input Operating Voltage Range: +6.0V to +19V
• Pre-programmed dsPIC33EP256MC504
• Drives up to a 15A BLDC motor
• ON/OFF momentary contact switch
• Reset momentary contact switch
• Spare user-programmable momentary contact switch
• PWM signal LED indicators
• PICkit 3 and MPLAB ICD 3 debugger interfaces
• Speed control potentiometer
• Terminal block for 5V and 12V Hall-effect sensors
• LIN terminal block for user communications use
• Configurable external MOSFET overcurrent protection
• Configurable PWM dead-time protection
• Configurable PWM blanking time for current switching spikes
• Complete “C” source code (provided on the board web page)

Typische Anwendungen

• Home Appliance
• Automotive Fuel
• Water, Ventilation Motors
• Permanent Magnetic Synchronous Motor Control

Weiterführende Informationen

• Datenblatt
• Produktseite des IC-Herstellers