| Topologie | Abwärtswandler |
| Eingangsspannung | 5.5-22 V |
| Ausgang 1 | 1.8 V / 10 A |
| IC-Revision | 1.0.0 |
The XRP779711EVB-DEMO-1 board is acomplete, four channel power system. Itprovides 1.5V, 1.2V 1.8V and 2.5V atmaximum currents of 10A, 10A, 6A and 6Arespectively. The 1.5V and 1.2V supplies canbe adjusted in 2.5mV increments, the 1.8Vand 2.5V supplies in 5mV increments. Theorder and ramp rates for each supply can beprogrammed to accommodate any sequencingrequirement. All power supply operations canbe controlled over an I2C interface. Faults,output voltages and currents can also bemonitored. Two GPIO and three PSIO signalsare available and can be programmed toprovide a variety of functions. UnusedGPIO/PSIO pins can be programmed as I/Oexpansion for a microcontroller. The board issupported by PowerArchitectTM 5.1 and plugsdirectly onto the interposer board acting as aninterface to Arduino controller.
XRP9711 Programmable Power Module
Channels 1 and 2 driving externalpower stages
Channel 3 and 4 internal converters
4 Channel Power System
Wide Input Voltage Range: 5.5V-22V
I2C Interface
Programming
− Monitoring
− Control
Artikel Nr. | Datenblatt | Simulation | Downloads | Status | Produktserie | λDom typ.(nm) | Emittierte Farbe | λPeak typ.(nm) | IV typ.(mcd) | VF typ.(V) | Chiptechnologie | 2θ50% typ.(°) | Pins | Version | Typ | Montageart | L(mm) | IR(A) | Betriebstemperatur | Verpackung | Arbeitsspannung(V (AC)) | IR 1(A) | PCB/Kabel/Panel | H(mm) | Betätigungskraft(g) | Elektrische Lebensdauer(Cycles) | Actuator-Farbe | Dampfphasenprozess | MusterVerfügbarkeit & Muster | ||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
![]() | SPECWL-SMCW SMT Mono-color Chip LED Waterclear, 570 nm, Hellgrün | Verfügbarkeit – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWL-SMCW SMT Mono-color Chip LED Waterclear | dominante Wellenlänge [typ.]570 nm | Emittierte FarbeHellgrün | Spitzen-Wellenlänge [typ.]572 nm | Lichtstärke [typ.]40 mcd | Durchlassspannung [typ.]2 V | ChiptechnologieAlInGaP | Abstrahlwinkel Phi 0° [typ.]140 ° | – | – | – | MontageartSMT | Länge3.2 mm | – | Betriebstemperatur -40 °C up to +85 °C | VerpackungTape and Reel | – | – | – | Höhe0.68 mm | – | – | – | – | –Verfügbarkeit prüfen | |||
![]() | SPECWL-SMCW SMT Mono-color Chip LED Waterclear, 605 nm, Bernstein | Verfügbarkeit – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWL-SMCW SMT Mono-color Chip LED Waterclear | dominante Wellenlänge [typ.]605 nm | Emittierte FarbeBernstein | Spitzen-Wellenlänge [typ.]610 nm | Lichtstärke [typ.]140 mcd | Durchlassspannung [typ.]2 V | ChiptechnologieAlInGaP | Abstrahlwinkel Phi 0° [typ.]140 ° | – | – | – | MontageartSMT | Länge3.2 mm | – | Betriebstemperatur -40 °C up to +85 °C | VerpackungTape and Reel | – | – | – | Höhe0.68 mm | – | – | – | – | –Verfügbarkeit prüfen | |||
![]() | SPECWL-SMCW SMT Mono-color Chip LED Waterclear, 625 nm, Rot | Verfügbarkeit – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWL-SMCW SMT Mono-color Chip LED Waterclear | dominante Wellenlänge [typ.]625 nm | Emittierte FarbeRot | Spitzen-Wellenlänge [typ.]630 nm | Lichtstärke [typ.]150 mcd | Durchlassspannung [typ.]2 V | ChiptechnologieAlInGaP | Abstrahlwinkel Phi 0° [typ.]140 ° | – | – | – | MontageartSMT | Länge3.2 mm | – | Betriebstemperatur -40 °C up to +85 °C | VerpackungTape and Reel | – | – | – | Höhe0.68 mm | – | – | – | – | –Verfügbarkeit prüfen | |||
![]() | SPECWR-PHD Stiftleisten - Einreihig, –, – | Simulation– | Verfügbarkeit – | Downloads7 Dateien | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWR-PHD Stiftleisten - Einreihig | – | – | – | – | – | – | – | Pins8 | – | TypGerade | MontageartTHT | Länge20.32 mm | Nennstrom3 A | Betriebstemperatur -40 °C up to +105 °C | VerpackungBeutel | Arbeitsspannung250 V (AC) | – | – | – | – | – | – | – | –Verfügbarkeit prüfen | |
![]() | SPECWS-TASV SMT Tact Switch 6x6 mm, –, – | Simulation– | Verfügbarkeit – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWS-TASV SMT Tact Switch 6x6 mm | – | – | – | – | – | – | – | – | – | – | – | – | Nennstrom0.05 A | Betriebstemperatur -40 °C up to +85 °C | VerpackungTape and Reel | – | – | – | Höhe5 mm | Betätigungskraft160 g | Elektrische Lebensdauer1000000 Cycles | Actuator farbeSchwarz | Dampfphasenprozessnicht spezifiziert | –Verfügbarkeit prüfen | ||
![]() | SPECWR-BHD 2.54 mm Wannenstiftleiste, –, – | Simulation– | Verfügbarkeit – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWR-BHD 2.54 mm Wannenstiftleiste | – | – | – | – | – | – | – | Pins20 | VersionLow Profile | TypAbgewinkelt | MontageartTHT | Länge33 mm | Nennstrom3 A | Betriebstemperatur -40 °C up to +125 °C | VerpackungTray | Arbeitsspannung250 V (AC) | Nennstrom [1]3 A | PCB/Kabel/PanelPCB | – | – | – | – | – | –Verfügbarkeit prüfen | ||
![]() | SPECWR-PHD Stiftleisten - Einreihig, –, – | Simulation– | Verfügbarkeit – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWR-PHD Stiftleisten - Einreihig | – | – | – | – | – | – | – | Pins1 | – | TypGerade | MontageartTHT | Länge2.54 mm | Nennstrom3 A | Betriebstemperatur -40 °C up to +105 °C | VerpackungBeutel | Arbeitsspannung250 V (AC) | – | – | – | – | – | – | – | –Verfügbarkeit prüfen | ||
![]() | SPECWR-PHD Stiftleisten - Einreihig, –, – Anstehende PCNAufgrund einer anstehenden PCN wird in Kürze eine Änderung am Bauteil durchgeführt. Anbei finden Sie die entsprechende PCN. Bei weiteren Fragen wenden Sie sich bitte an Ihren Vertriebsmitarbeiter. | Simulation– | Verfügbarkeit – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWR-PHD Stiftleisten - Einreihig | – | – | – | – | – | – | – | Pins6 | – | TypGerade | MontageartTHT | Länge15.24 mm | Nennstrom3 A | Betriebstemperatur -40 °C up to +105 °C | VerpackungBeutel | Arbeitsspannung250 V (AC) | – | – | – | – | – | – | – | –Verfügbarkeit prüfen | ||
![]() | SPECWR-PHD Stiftleisten - Zweireihig, –, – | Simulation– | Verfügbarkeit – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWR-PHD Stiftleisten - Zweireihig | – | – | – | – | – | – | – | Pins10 | – | TypGerade | MontageartTHT | Länge12.7 mm | Nennstrom3 A | Betriebstemperatur -40 °C up to +105 °C | VerpackungBeutel | Arbeitsspannung250 V (AC) | – | – | – | – | – | – | – | –Verfügbarkeit prüfen | ||
![]() | SPECWR-WTB 1.25 mm Male Header, –, – | Simulation– | Verfügbarkeit – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWR-WTB 1.25 mm Male Header | – | – | – | – | – | – | – | Pins4 | – | TypVertikal | MontageartSMT | Länge9.75 mm | Nennstrom1 A | Betriebstemperatur -40 °C up to +85 °C | VerpackungTape and Reel | Arbeitsspannung125 V (AC) | Nennstrom [1]1 A | PCB/Kabel/PanelPCB | – | – | – | – | – | –Verfügbarkeit prüfen |
| Erwartete Verfügbarkeit | Eingehender Bestand | Menge |
|---|---|---|
| Aktuelle Verfügbarkeit | – | – |