| Topologie | Sonstige Topologie |
| IC-Revision | 1A |
A well laid out PCB does not radiate much EMI all by itself from the current carrying traces. In order to get EMI compliance a PCB should have:- Ideally six layer PCB with two full ground planes. Four layer PCBs are okay.- Make sure there is sufficient vias between the ground planes.- Make sure to minimize the switching current loops on the board.- Current carrying traces must be kept as short as possible and running on a layer close to the ground plane.- Power ground plane and the signal ground must be connected at only one point.
Artikel Nr. | Datenblatt | Simulation | Downloads | Status | Produktserie | Z @ 100 MHz(Ω) | Zmax(Ω) | Testbedingung Zmax | IR(mA) | Z @ 1 GHz(Ω) | H(mm) | Typ | MusterVerfügbarkeit & Muster | ||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
![]() | SPECWE-MPSB EMI Multilayer Power Suppression Bead, 100 Ω, 160 Ω | Verfügbarkeit – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWE-MPSB EMI Multilayer Power Suppression Bead | Impedanz @ 100 MHz100 Ω | Maximale Impedanz160 Ω | Maximale Impedanz1100 MHz | Nennstrom8000 mA | Impedanz @ 1 GHz150 Ω | Höhe2.3 mm | TypHochstrom | –Verfügbarkeit prüfen |
| Erwartete Verfügbarkeit | Eingehender Bestand | Menge |
|---|---|---|
| Aktuelle Verfügbarkeit | – | – |