| Topologie | Sperrwandler |
| Eingangsspannung | 90-264 V |
| Ausgang 1 | 12 V / 4 A |
| IC-Revision | 1.0 |
The ETA8047 is a high performance peak current mode PWM controller. The ETA8047 uses quasi-resonant and frequency foldback techniques to reduce EMI and improve average efficiency, and to meet the latest level VI energy efficiency standards with sufficient margin. Through the optocoupler and secondary side control circuit, a very low standby power consumption, good dynamic response and precise voltage regulation are achieved. With the built-in quick startup procedure, the ETA8047 can achieve very short rise times even with large capacitive loads. The soft-start circuit keeps the output voltage free from overshoot at power-up. Under full load conditions, ETA8047 can work in CCM mode and DCM mode to meet different types of applications. The quasi-resonant (QR) valley technique always works in DCM mode. The ETA8047 has a 7 -37V wide VCC operating voltage range and can be used directly in a Class A Quick Charge solution. The ETA8047 integrates comprehensive protection. When over temperature, input/output overvoltage, winding short-circuit, short-circuit of current sensing resistor, open-loop, output short-circuit, overload, overcurrent, etc., the fault condition is detected to enter the auto-restart hiccup mode. When the fault is removed, it will automatically resume normal operation. The cycle-by-cycle current limit ensures safe operation even during failure modes and recovery. The ETA8047 is suitable for applications up to 50 watts. The ETA8047 is available in a SOT23-6 package.
Artikel Nr. | Datenblatt | Simulation | Downloads | Status | Produktserie | C | Sicherheitsklasse | dV/dt(V/µs) | DF @ 1 kHz(%) | RISO | Raster(mm) | Verpackung | Tol. C | Bauform | Qmin. | DF(%) | Keramiktyp | Fl(mm) | Betriebstemperatur | Q(%) | Endurance(h) | IRIPPLE(mA) | RESR(mΩ) | ILeak(µA) | Ø D(mm) | IR(A) | L(mH) | RDC max.(mΩ) | VR(V (AC)) | VT(V (AC)) | Material | L(mm) | B(mm) | H(mm) | Montageart | Muster | |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
![]() | WCAP-FTX2 Folienkondensatoren, Across the mains, 220 nF | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWCAP-FTX2 Folienkondensatoren | Kapazität220 nF | SicherheitsklasseX2 | Spannungsanstiegsgeschwindigkeit300 V/µs | Verlustfaktor0.1 % | Isolationswiderstand30 GΩ | Raster10 mm | VerpackungKarton | Kapazität±10% | BauformRaster 10 mm | – | – | – | – | Betriebstemperatur -40 °C up to +105 °C | – | – | – | – | – | – | – | – | – | Nennspannung275 V (AC) | – | – | Länge13 mm | Breite8 mm | Höhe14 mm | MontageartBoxed THT | ||||
![]() | WE-CMB Stromkompensierte Netzdrossel, –, – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWE-CMB Stromkompensierte Netzdrossel | – | – | – | – | – | – | – | – | BauformM | – | – | – | – | Betriebstemperatur -40 °C up to +125 °C | – | – | – | – | – | – | Nennstrom1.5 A | Induktivität20 mH | Gleichstromwiderstand270 mΩ | Nennspannung250 V (AC) | Prüfspannung1500 V (AC) | MaterialMnZn | Länge23 mm | Breite13.8 mm | Höhe25.5 mm | MontageartTHT | ||||
![]() | WE-CMB HC Stromkompensierte Netzdrossel, –, – | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWE-CMB HC Stromkompensierte Netzdrossel | – | – | – | – | – | – | – | – | BauformTyp S | – | – | – | – | Betriebstemperatur -40 °C up to +125 °C | – | – | – | – | – | – | Nennstrom5 A | Induktivität0.7 mH | Gleichstromwiderstand15 mΩ | Nennspannung250 V (AC) | Prüfspannung1500 V (AC) | MaterialMnZn | Länge18.5 mm | Breite14.5 mm | Höhe22 mm | MontageartTHT | ||||
![]() | WCAP-PTG5 Aluminium-Polymer-Kondensatoren, –, 820 µF | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWCAP-PTG5 Aluminium-Polymer-Kondensatoren | Kapazität820 µF | – | – | – | – | Raster5 mm | VerpackungAmmopack | Kapazität±20% | – | – | Verlustfaktor10 % | – | – | – | – | Endurance 2000 | Rippelstrom5500 mA | – | Leckstrom1000 µA | Durchmesser10 mm | – | – | – | Nennspannung16 V (AC) | – | – | Länge12.5 mm | – | – | MontageartRadial THT | ||||
![]() | WCAP-PT5H Aluminium-Polymer-Kondensatoren, –, 330 µF | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWCAP-PT5H Aluminium-Polymer-Kondensatoren | Kapazität330 µF | – | – | – | – | Raster3.5 mm | VerpackungAmmopack | Kapazität±20% | – | – | Verlustfaktor8 % | – | – | – | – | Endurance 5000 | Rippelstrom5600 mA | ESR (Serienersatzwiderstand)9 mΩ | Leckstrom528 µA | Durchmesser8 mm | – | – | – | Nennspannung16 V (AC) | – | – | Länge11.5 mm | – | – | MontageartRadial THT | ||||
| WCAP-CSGP MLCCs 50 V(DC), –, 470 pF | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWCAP-CSGP MLCCs 50 V(DC) | Kapazität470 pF | – | – | – | Isolationswiderstand10 GΩ | – | Verpackung7" Tape & Reel | Kapazität±5% | Bauform0805 | – | – | KeramiktypNP0 Klasse I | Pad Dimension0.5 mm | Betriebstemperatur -55 °C up to +125 °C | Güte1000 % | – | – | – | – | – | – | – | – | Nennspannung50 V (AC) | – | – | Länge2 mm | Breite1.25 mm | Höhe0.8 mm | – | |||||
| WCAP-CSGP MLCCs 25 V(DC), –, 100 nF | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWCAP-CSGP MLCCs 25 V(DC) | Kapazität100 nF | – | – | – | Isolationswiderstand5 GΩ | – | Verpackung7" Tape & Reel | Kapazität±10% | Bauform0805 | Güte [1]600 | Verlustfaktor3.5 % | KeramiktypX7R Klasse II | Pad Dimension0.5 mm | Betriebstemperatur -55 °C up to +125 °C | – | – | – | – | – | – | – | – | – | Nennspannung25 V (AC) | – | – | Länge2 mm | Breite1.25 mm | Höhe0.8 mm | – | |||||
| WCAP-CSGP MLCCs 50 V(DC), –, 4.7 µF | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWCAP-CSGP MLCCs 50 V(DC) | Kapazität4.7 µF | – | – | – | Isolationswiderstand0.02 GΩ | – | Verpackung7" Tape & Reel | Kapazität±10% | Bauform1206 | Güte [1]600 | Verlustfaktor10 % | KeramiktypX7R Klasse II | Pad Dimension0.5 mm | Betriebstemperatur -55 °C up to +125 °C | – | – | – | – | – | – | – | – | – | Nennspannung50 V (AC) | – | – | Länge3.2 mm | Breite1.6 mm | Höhe1.6 mm | – | |||||
| WCAP-CSGP MLCCs 100 V(DC), –, 1 nF | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWCAP-CSGP MLCCs 100 V(DC) | Kapazität1 nF | – | – | – | Isolationswiderstand10 GΩ | – | Verpackung7" Tape & Reel | Kapazität±5% | Bauform0805 | Güte [1]1000 | – | KeramiktypNP0 Klasse I | Pad Dimension0.5 mm | Betriebstemperatur -55 °C up to +125 °C | Güte1000 % | – | – | – | – | – | – | – | – | Nennspannung100 V (AC) | – | – | Länge2 mm | Breite1.25 mm | Höhe0.8 mm | – | |||||
![]() | WCAP-CSMH Mid and High Voltage, –, 1 nF | Downloads8 Dateien | Status Aktivi| Produktion ist aktiv. Erwartete Lebenszeit: >10 Jahre. | ProduktserieWCAP-CSMH Mid and High Voltage | Kapazität1 nF | – | – | – | Isolationswiderstand10 GΩ | – | Verpackung7" Tape & Reel | Kapazität±5% | Bauform1206 | Güte [1]1000 | – | KeramiktypNP0 Klasse I | Pad Dimension0.6 mm | Betriebstemperatur -55 °C up to +125 °C | Güte1000 % | – | – | – | – | – | – | – | – | Nennspannung500 V (AC) | – | – | Länge3.2 mm | Breite1.6 mm | Höhe1.6 mm | – |