IC manufacturers STMicroelectronics

IC manufacturers (103)

STMicroelectronics VIPER26 | Demoboard STEVAL-VP26K01B

15 V / 100 mA high voltage buck converter reference design based on VIPER26K

Overview

TopologyBuck Converter
Input voltage60-870 V
Output 115 V / 0.1 A
IC revision1

Description

The device is a high voltage converter smartly integrating a 1050 V avalanche-rugged power section, with a PWM current mode control. The 1050 V-BV power MOSFET allows to extend input voltage range, and reduce the size of the DRAIN snubber circuit. This IC meets the most stringent energy-saving standards as it has very low consumption and operates in burst mode under light load.The integrated HV startup, sense-FET, error amplifier and oscillator with jitter allow a complete application to be designed with the minimum number of components.The VIPer26K supports the most common SMPS topologies such as: isolated flyback with optocoupler, primary-side regulation, non-isolated flyback with resistive feedback, buck, and buck boost.

Features

  • 1050 V avalanche-rugged power MOSFET allowing ultra-wide VAC input range to be covered
  • Embedded HV startup and sense-FET
  • Current mode PWM controller
  • Drain current limit protection:
  • 500 mA (VIPER265K)
  • 700 mA (VIPER267K)
  • Jittered switching frequency reduces the EMI filter cost: 60 kHz ± 4kHz
  • Standby power < 30 mW at 230 VAC
  • Embedded E/A with 3.3 V reference
  • Safe auto-restart after a fault condition
  • Hysteretic thermal shutdown
  • Built-in soft-start for improved system reliability

Typical applications

  • Auxiliary power supply for appliances / SMPS for set-top boxes, DVD players and recorders
  • Power metering
  • LED drivers

Products

Order Code
Data­sheet
Simu­lation
Downloads
Status
Product series
C
Tol. C
VR(V (DC))
Size
Operating Temperature
DF(%)
RISO
Ceramic Type
L(mm)
W(mm)
H(mm)
Fl(mm)
Packaging
L(µH)
IR(A)
ISAT,10%(A)
RDC max.(mΩ)
fres(MHz)
Version
Samples
WCAP-CSGP MLCCs 50 V(DC), 1.5 nF, ±10%
Simu­lation
Status Activei| Production is active. Expected lifetime: >10 years.
Capacitance1.5 nF
Capacitance±10% 
Rated Voltage50 V (DC)
Size0603 
Operating Temperature -55 °C up to +125 °C
Dissipation Factor2.5 %
Insulation Resistance10 GΩ
Ceramic TypeX7R Class II 
Length1.6 mm
Width0.8 mm
Height0.8 mm
Pad Dimension0.4 mm
Packaging7" Tape & Reel 
WE-TI Radial Leaded Wire Wound Inductor, –, –
Simu­lation
Status Activei| Production is active. Expected lifetime: >10 years.
Size1018 
Operating Temperature -40 °C up to +125 °C
Length11 mm
Width11 mm
Height19 mm
Inductance1000 µH
Rated Current0.8 A
Saturation Current @ 10%1 A
DC Resistance860 mΩ
Self Resonant Frequency1.1 MHz
VersionHeat Shrinking Tube