Texas Instruments DP83825IRMQR | Demoboard TIDA-010046 PD

Beschreibung

This reference design provides a cost-optimized solution for 10 to 100Mbps using the low-power Ethernet physical layer (PHY) DP83825 supporting 150m reach over CAT5e cable which is beyond the standard Ethernet distance limitation of 100 m (328 feet). Also, demonstrating power delivery over Ethernet cable along with data communication using IEEE802.3at Type-1 (13W) PoE-PD TPS23755 device with integrated primary side regulated Flyback DC/DC controller. This reference design is pre-compliance tested for radiated emissions, ESDs, and EFTs.

Eigenschaften

• Ultra Small Form Factor 10/100 Mbps PHY : QFN 3 mm × 3 mm, 24 pin
• Cable reach > 150 meters
• Very low power consumption < 127 mW
• Small system solution : integrated MDI and MAC termination resistors
• Programmable energy saving modes– Active sleep – Deep power-down– Energy Efficient Ethernet (EEE) IEEE 802.3az– EEE support for legacy MAC– Wake-on-LAN (WoL)
• Voltage mode line driver
• MAC interface : RMII (master and slave mode)
• Single 3.3 V power supply
• I/O voltages: 1.8 V and 3.3 V
• Repeater : RMII back-to-back mode in unmanaged mode
• MDC/MDIO Interface for configuration and status
• Fast link drop modes
• Diagnostics features– TDR-based cable diagnostics for open, short– Built-in packet generator – Multiple loopbacks
• Programmable Hardware interrupt pin
• Operating temperature range: –40°C to 85°C
• Compliant to IEEE 802.3 100BASE-TX and10BASE-Te specification

Typische Anwendungen

• Electronic point of sale / Factory automation
• Printers
• Consumer electronics: STB, OTT, IPTV, game consoles
• Building automation: IP camera, HMI

Weiterführende Informationen

• Datenblatt
• Produktseite des IC-Herstellers