SG-Micro SGM64200 | Demoboard SGM4200

Beschreibung

The SGM64200 integrates two synchronous Buck controllers which can be configured as two independent single-phase outputs or one dual-phase output. Two devices can also be linked up as a master-slave through an external pin to provide four single-phase outputs or two dual-phase outputs. The switching phases of linked devices are adjustable to achieve four phases interleaving. The device accepts an input range from 3V to 20V with a precise reference voltage of 0.6V.

Eigenschaften

• Two Single-Phase or One Dual-Phase Outputs
• SYNC Pin with One Cycle Clock Recovery
• PHASE Pin with 0°/180° or 90°/270° Operation
• Two Devices in Master-Slave Mode
• Wide Input Supply from 3V to 20V
• Precise Reference of 600mV: ±0.75%
• Adjustable Output from 0.6V to 5.4V
• Adjustable Frequency from 100kHz to 1MHz
• Voltage Mode PWM with Input Feedforward
• Dual N-MOSFET Drivers with Integrated Bootstrap Switch
• Accurate Inductor DCR or Resistor Current Sense
• Individual Power Good Open-Drain Pin
• Individual Enable Pin & Programmable Soft-Start Time Capable of Pre-Bias Startup
• Accurate Current Sharing in Dual-Phase
• Remote Output Sense Amplifier in Dual-Phase
• Individual Over-Current Limit Set
• Cycle-by-Cycle Over-Current Limit with Hiccup
• Input Supply Under-Voltage Lock-Out Pin
• Individual Output Over-Voltage/Under-Voltage Protection
• Thermal Shutdown Protection
• Available in a Green TQFN-5×5-32AL Package

Typische Anwendungen

• Servers, Telecom Base Station, Switcher and Router Networking

Weiterführende Informationen

• Datenblatt
• Produktseite des IC-Herstellers