ICCS Micro CAN 4 I/O – Standalone module or extension module to an existing CAN bus system.

The module is equipped with a Freescale HCS08 processor with flash-technology and offers multiple programming possibility. Therefore, an extensive control system can be built up. The software boot loader has the ability to update the firmware directly through the CAN bus interface.

The integrated CAN bus interface supports the data with the vehicle and Wake-On-CAN feature.


  • Input and output extensions for CAN bus systems
  • Sensors to CAN module
  • Programmable logic allows local execution of complex tasks and data preformatting
Technical Data
General Information
Connector 9 pins DIN
Dimensions 30 x 30 x 40 mm
Weight ~ 30 g
Operating temperature -40 °C to 85 °C (no full load at 85 °C)
Storage temperature -40 °C to 85 °C
Ingress protection IP 53
EMC ECE10 Rev.4 : E1 7199
Operating voltage 9 to 30 V
Pre-fusing (recommended) 10 A
Current consumption 25 mA
Processor type Freescale HCS08
Clock frequency 20 MHz
Flash memory 60 kB
RAM 4 kB
EEPROM 1 kB available for graphical programming


Programming the ICCS Micro CAN 4I/O is carried out using ICCS SDK Plus software.

In the development phase, we support you in the creation of programs.

If you prefer to create your parameters or create programs by yourself try our software development kit ICCS SDK Plus which you can borrow for three month free of charge.