IC manufacturers Texas Instruments

IC manufacturers (95)

Texas Instruments AFE77XX

Quad-channel RF transceiver with dual feedback paths and four PLLs

Overview

TopologyOther Topology
IC revisionB

Description

The AFE7769 device is a high-performance, multichannel transceiver, integrating four direct up-conversion transmitter chains, four direct down-conversion receiver chains, and two wideband RF sampling digitizing auxiliary chains (feedback paths). The high dynamic range of the transmitter and receiver chains enables wireless base stations to generate and receive 2G, 3G, 4G, and 5G signals.The low power dissipation and large channel integration of the AFE7769 allows the device to address the power and size constraints of 4G and 5G massive MIMO base stations. The wideband and high dynamic range feedback path can assist the Digital Pre-Distortion (DPD) of the power amplifiers in the transmitter chain. The fast SerDes speed can help reduce the number of lanes required to transfer the data in and out.Each receiver chain of the AFE7769 includes a 28-dB range digital step attenuator (DSA), followed by a wideband passive IQ demodulator, and a baseband amplifier with integrated programmable antialiasing low pass filters, driving a continuous-time sigma-delta ADC. The RX chain can receive an instantaneous bandwidth (IBW) up to 200 MHz. Each receiver channel has two analog peak power detectors and various digital power detectors to assist an external or internal autonomous AGC control for receiver channels, and a RF overload detector for device reliability protection. The integrated QMC (quadrature mismatch compensation) algorithm is capable to continuously monitor and correct for the RX chain I and Q imbalance mismatch without the need to inject any specific signals or perform offline calibration.Each transmitter chain includes two 14-bit, 3-Gsps IQ DACs, followed by a programmable reconstruction and DAC image rejection filter, an IQ modulator driving a wideband RF amplifier with 39-dB range gain control. The TX chain integrated QMC and LO leakage cancellation algorithms, leveraging the FB path can constantly track and correct for the TX chain IQ mismatch and LO leakage.Each FB path is based on RF sampling architecture, and includes an input RF DSA driving a 14-bit, 3-Gsps RF ADC. The direct sampling architecture provides an inherently wideband receiver chain and simplifies the calibration of the TX chains impairments. The FB path integrates two independent NCO that allows a fast switching between two observed RF input bands.The synthesizer section integrates four fractional-N RF PLL that can generate four different RF LO, allowing the device to support up to two different bands, each one configured as two transmitters, two receivers and one feedback paths.

Features

  • Quad transmitters based on direct up-conversion architecture:
  • Up to 600 MHz of RF transmitted bandwidth per chain
  • Quad receivers based on 0-IF down-conversion architecture:
  • Up to 200 MHz of RF received bandwidth per chain
  • Feedback chain based on RF sampling ADC:
  • Up to 600 MHz of RF received bandwidth
  • RF frequency range: 600 MHz to 6 GHz
  • Four wideband fractional-N PLL, VCO for TX and RX LO
  • Dedicated integer-N PLL, VCO for data converters clock generation
  • JESD204B and JESD204C SerDes interface support:
  • 8 SerDes transceivers up to 29.5 Gbps
  • 8b/10b and 64b/66b encoding
  • 16-bit, 12-bit, 24-bit and 32-bit formatting
  • Subclass 1 multi-device synchronization
  • Package: 17-mm × 17-mm FCBGA, 0.8-mm pitch

Typical applications

  • Macro remote radio unit (RRU), Small cell base station, Active antenna system mMIMO (AAS), Distributed Antenna Systems (DAS), Repeater

Products

Order Code Data­sheet Simu­lation Downloads Product seriesL
(µH)
IR,40K
(A)
ISAT,10%
(A)
ISAT,30%
(A)
RDC max.
(mΩ)
fres
(MHz)
MountλDom typ.
(nm)
Emitting ColorλPeak typ.
(nm)
IV typ.
(mcd)
VF typ.
(V)
Chip Technology50% typ.
(°)
CTol. CVR
(V (DC))
SizeOperating TemperatureDF
(%)
RISOCeramic TypeL
(mm)
W
(mm)
H
(mm)
Fl
(mm)
PackagingIRP,40K
(A)
RDC typ.
(mΩ)
V
(V)
Samples
78438356010SPEC
8 files WE-MAIA SMT Power Inductor 1 10.1 5.3 11.5 15 55 SMT 4020 -40 °C up to +125 °C 4.1 4.1 2.1 12
78438356012SPEC
8 files WE-MAIA SMT Power Inductor 1.2 8.9 5.55 11.2 18 52 SMT 4020 -40 °C up to +125 °C 4.1 4.1 2.1 15
74438336015SPEC
9 files WE-MAPI SMT Power Inductor 1.5 0 2.95 5.85 39 51 SMT 3020 -40 °C up to +125 °C 3 3 2 5.35 33 80
78438356015SPEC
8 files WE-MAIA SMT Power Inductor 1.5 8.6 4.8 10.2 19 48 SMT 4020 -40 °C up to +125 °C 4.1 4.1 2.1 16
150060VS75000SPEC
6 files WL-SMCW SMT Mono-color Chip LED Waterclear SMT 570 Bright Green 572 40 2 AlInGaP 140 0603 -40 °C up to +85 °C 1.6 0.8 0.7 Tape and Reel
150060BS75000SPEC
25 files WL-SMCW SMT Mono-color Chip LED Waterclear SMT 470 Blue 465 145 3.2 InGaN 140 0603 -40 °C up to +85 °C 1.6 0.8 0.7 Tape and Reel
885012105005SPEC
5 files WCAP-CSGP MLCCs 6.3 V(DC)680 nF ±20% 6.3 0402 -55 °C up to +85 °C 100.2 GΩ X5R Class II 1 0.5 0.5 0.25 7" Tape & Reel
Samples
Order Code Data­sheet Simu­lation Downloads Product seriesL
(µH)
IR,40K
(A)
ISAT,10%
(A)
ISAT,30%
(A)
RDC max.
(mΩ)
fres
(MHz)
MountλDom typ.
(nm)
Emitting ColorλPeak typ.
(nm)
IV typ.
(mcd)
VF typ.
(V)
Chip Technology50% typ.
(°)
CTol. CVR
(V (DC))
SizeOperating TemperatureDF
(%)
RISOCeramic TypeL
(mm)
W
(mm)
H
(mm)
Fl
(mm)
PackagingIRP,40K
(A)
RDC typ.
(mΩ)
V
(V)
Samples