Onsemi FUSB3307 | Demoboard FUSB3307MX-PPS-GEVB EVBUM2710/D

Beschreibung

The FUSB3307 evaluation board (GEVB), or kit (EVK), is a complete platform to evaluate the Type?C interface detection and USB Power Delivery 3.0 solution the FUSB3307 provides. The EVB is designed for both stand?alone operation and connection to test equipment for specific testing requirements. Using a single DC power supply, the EVB functions as a source only port. The various FUSB3307 evaluation boards contain a USB Type?C source controller supporting USB Power Delivery (PD) 3.0 with PPS (Programmable Power Supply) based on USB PD 3.0 standards, as well as a 4?stage buck boost controller, delivering VBUS levels from 3.3 V to 21 V, and supporting nominal current loads up to 5 A. The evaluation board has a VBAT connector for a DC power supply. It connects to the input switch of the NCV81599 DC to DC 4?Switch Buck Boost Controller. The FUSB3307 is used for CV/CC control by providing feedback compensation to the NCV81599 controller. On the EVB, there are multiple test points for device validation. For example, VBUS and GND_SNS test points can be used for VBUS load testing.

Eigenschaften

• Wide Input Voltage Range 4.5 V ~ 32 V
• Wide Output Voltage Range 3.3 V ~ 21 V
• Type−C r1.4 / USB PD 3.0 v1.2 Compliant
• USB−IF TID # 1430
• Type−C Source Only
• Detects Cable Marker Identity
• VCONN Supply
• CV/CC Control with CATH Pin
• On Board 5 mOhm Rsense Resistor
• Over−Current/Short−Circuit Protection (OCP)
• Auto−tuning OCP for Low Output Voltages
• Over−Temperature Protection (OTP)
• Over− and Under−Voltage Protection (OVP/UVP)
• Cable Fault Detection
• External NFET for VBUS Control
• Easily Accessible Test Points for Rapid Evaluation and Performance Measurements

Typische Anwendungen

• Battery Wall Chargers for Tablet PC’s and Laptops, DC−DC Car Chargers for Individual Port Power Control

Weiterführende Informationen

• Datenblatt
• Produktseite des IC-Herstellers